USA Lab RE-200A Rotary Evaporator Probe Connector Replacement Guide
This guide explains how to remove and replace the probe connector on the RE-200A rotary evaporator. Steps include disconnecting three PCB wires, removing the existing connector, installing the new connector, and reconnecting all wiring for proper operation.
Link to RE-200A Rotary Evaporator Probe Connector Replacement Guide
Quick Facts
- Wires to Remove: 3
- Connector Location: Mounted in the housing panel
- Tools Required: Screwdriver
- Final Verification: Test unit for proper operation
STEP 1 — Remove the PCB Wires
- Once the back plate is removed, unscrew the three wires from the PCB connector. (Shown in images on page 1)
STEP 2 — Remove the Probe Connector
- Unscrew the probe connector from the housing.
- Slide it out of the opening.
STEP 3 — Install the New Probe Connector
- Insert the new probe connector into the housing and screw it on tightly.
STEP 4 — Reconnect PCB Wiring
- Screw all three wires back into the PCB connector.
- A wiring diagram is shown on page 2 to illustrate wire placement.
STEP 5 — Reassemble and Test
- Reconnect all pieces and test the unit to ensure proper operation.
Contact & Support
For questions, replacement parts, or troubleshooting:
📞 734-855-4890
📧 support@usalabequipment.com